Audi 80/90/Coupe

since 1986-1991 release

Repair and operation of the car



Audi 80/90/Coupe
+ 1.2. Identification of the car
+ 2. Engines, carburetors
3. Lubrication system
+ 4. Cooling system
+ 5. Fuel system
+ 6. Exhaust system
+ 7. System of ignition
- 8. Transmission
   8.1.2. A fork - the main cylinder of coupling
   8.1.3. Press clutch plate
   8.1.4. Malfunctions of coupling
   + 8.2. Mechanical transmission 012
   + 8.3. Mechanical transmission 01A
   - 8.4. Automatic transmission 089
      8.4.2. Lever and rope of the lever of gear shifting
      8.4.3. Lock of automatic gear shifting
      8.4.4. Mechanism of management of a butterfly valve
      8.4.5. Removal and installation of the transmission
      8.4.6. Check of the moments of gear shifting
      8.4.7. Main transfer
      8.4.8. Differential
   + 8.5. Automatic transmission 087
   8.6. Dismantling and assembly of automatic transmissions
   8.7. Block of valves
   + 8.8. Automatic transmission 097
+ 9. Suspension brackets, wheels
+ 10. Brake system
+ 11. Steering
+ 12. Body, salon
+ 13. Air conditioning system
+ 14. Electric equipment


8.4.5. Removal and installation of the transmission

Removal

PERFORMANCE ORDER
1) remove the accumulator
2) remove the top bolts of fastening of the engine and transmission
3) disconnect a wire of grounding of the transmission
4) disconnect the socket of connection of a speedometer
5) establish a support under the engine
6) lift the car
7) remove bolts from forward fastening of the engine
8) remove a forward exhaust pipe
9) remove the hydrotransformer filter
10) remove bolts of fastening of the hydrotransformer (3 bolts)
11) disconnect hoses of a radiator of liquid of cooling of the automatic transmission on a back part of the engine, under the shelf of the accumulator
12) remove the filter on the right side
13) disconnect half shafts from the main transfer
14) disconnect the feeding tube of liquid of cooling of the automatic transmission
15) remove an arm of a rope of gear shifting and disconnect a rope from the transmission
16) remove plastic clips from ropes of seat belts
17) disconnect an accelerator rope from the lever of switching of the transmission
18) remove cross fastening behind the transmission
19) lift the transmission by means of the elevator and remove bolts of fastening of the transmission
20) lower the elevator and lift the engine, having lifted an engine support (the transmission at the same time slightly will bend for removal simplification)
21) remove the remaining bolts of fastening of the transmission and engine
22) separate the spherical hinge / case of the bearing of the left wheel and pull out a half shaft
23) disconnect the transmission from the engine
24) accurately lower the engine, at the same time support the hydrotransformer that it did not fall

Installation

Installation is carried out upside-down removals, at the same time pay attention to the following:

establish and twirl bolts of fastening of the transmission the last.