Audi 80/90/Coupe

since 1986-1991 release

Repair and operation of the car

Audi 80/90/Coupe
+ 1.2. Identification of the car
+ 2. Engines, carburetors
3. Lubrication system
+ 4. Cooling system
+ 5. Fuel system
+ 6. Exhaust system
+ 7. System of ignition
+ 8. Transmission
- 9. Suspension brackets, wheels
   9.1.1. Elimination of resonance / vibration of a cross-piece (4-cylinder models)
   9.1.2. Change of a design of a forward suspension bracket
   9.1.3. Half shaft
   9.1.4. Suspension bracket rack
   9.1.5. CV JOINTS
   9.1.6. Suspension bracket rack (all-wheel drive models)
   9.1.7. CV JOINTS (all-wheel drive models)
   - 9.2. Back suspension bracket
      9.2.1. Oil cap
      9.2.2. Wheel bearings
      9.2.3. Removal and installation of the back bridge
      9.2.4. Suspension bracket rack
      9.2.5. Change of a design of a back suspension bracket
   + 9.3. Wheels and tires
+ 10. Brake system
+ 11. Steering
+ 12. Body, salon
+ 13. Air conditioning system
+ 14. Electric equipment

9.2.5. Change of a design of a back suspension bracket

GENERAL INFORMATION

Prevention

The modified elements of a suspension bracket cannot be installed on cars of old models.

Change of a design of a back suspension bracket of the models produced since 1990 – for all-wheel drive models

1. A rack of the shock-absorber / wheel bearing with ears for fastening of connecting draft of the stabilizer of cross stability
2. 25 N. of m, always replace
3. Connecting draft
4. Cross draft length of the modified cross drafts differs from length of drafts of old model
5. 45 N. of m, always replace
6. Самоконтрящаяся a nut, always replace

7. Stabilizer of cross stability
8. Cross-piece of a back suspension bracket
the arm of fastening of cross draft / stabilizer of cross stability is modified
9. Rubber plug
10. 90 N. of m.
tighten, only when the car costs on the earth
11. Clip
12. 35 N.m.