Audi 80/90/Coupe

since 1986-1991 release

Repair and operation of the car


Audi 80/90/Coupe
+ 1.2. Identification of the car
+ 2. Engines, carburetors
3. Lubrication system
+ 4. Cooling system
+ 5. Fuel system
+ 6. Exhaust system
+ 7. System of ignition
+ 8. Transmission
- 9. Suspension brackets, wheels
   9.1.1. Elimination of resonance / vibration of a cross-piece (4-cylinder models)
   9.1.2. Change of a design of a forward suspension bracket
   9.1.3. Half shaft
   9.1.4. Suspension bracket rack
   9.1.5. CV JOINTS
   9.1.6. Suspension bracket rack (all-wheel drive models)
   9.1.7. CV JOINTS (all-wheel drive models)
   + 9.2. Back suspension bracket
   + 9.3. Wheels and tires
+ 10. Brake system
+ 11. Steering
+ 12. Body, salon
+ 13. Air conditioning system
+ 14. Electric equipment


https://www.youtube.com/watch?v=u1d9-JRZ12M

9.1.2. Change of a design of a forward suspension bracket
GENERAL INFORMATION

Change of a design of a forward suspension bracket of the models produced since 1990

1. Rack of the wheel bearing and shock-absorber
with a uvula for fastening of connecting draft of the stabilizer of cross stability
the modified shock-absorbers are installed
2. 45. N of m.
3. Connecting draft
4. 45 N. of m.
always replace
5. Lever of a forward suspension bracket
it is modified for the purpose of removal of fastening of connecting draft
6. Cross-piece of a forward suspension bracket

7. Stabilizer of cross stability
it is modified
8. Rubber plug
there are plugs of various diameters depending on diameter of the stabilizer
9. Clip
it is modified
10. 35 N. of m.
always replace
twist, only when the car costs on the earth

Prevention

The modified elements of a suspension bracket cannot be installed on cars of old models.

Change of a design of a forward suspension bracket of the models produced since 1990

1. Plug
2. Suspension bracket lever
levers of a suspension bracket differ for the left and right parties
3. Bolt
install in the suspension bracket lever against the stop

4. Spherical hinge
spherical hinges differ for the left and right parties
trailer diameter = 19.0 mm
do not expand a nest in a rack of the wheel bearing at removal / installation
adjust disorder of forward wheels after installation
5. Washer
6. 65 N. of m.
Prevention

The modified elements of a suspension bracket cannot be installed on cars of old models.