Audi 80/90/Coupe

since 1986-1991 release

Repair and operation of the car


Audi 80/90/Coupe
+ 1.2. Identification of the car
+ 2. Engines, carburetors
3. Lubrication system
+ 4. Cooling system
+ 5. Fuel system
+ 6. Exhaust system
+ 7. System of ignition
+ 8. Transmission
- 9. Suspension brackets, wheels
   9.1.1. Elimination of resonance / vibration of a cross-piece (4-cylinder models)
   9.1.2. Change of a design of a forward suspension bracket
   9.1.3. Half shaft
   9.1.4. Suspension bracket rack
   9.1.5. CV JOINTS
   9.1.6. Suspension bracket rack (all-wheel drive models)
   9.1.7. CV JOINTS (all-wheel drive models)
   + 9.2. Back suspension bracket
   - 9.3. Wheels and tires
      9.3.2. Disorder / convergence of wheels
+ 10. Brake system
+ 11. Steering
+ 12. Body, salon
+ 13. Air conditioning system
+ 14. Electric equipment


9.3. Wheels and tires

9.3.1. Technical characteristics
GENERAL INFORMATION

Model
Tire size
Wheels
Depth of a disk/diameter of a ring of bolts of fastening of a wheel
Audi-80
175/70 HR 14
5-1/2 J x 14 *
45/108
Audi-90
195/60 HR 14
6 J x 14
45/108
Spare wheel
115/70 R 15
4 J x 14
56/108
125/90 R 15
4 J x 14
45/108

* wheels with steel disks

Wheel assembled

1. Tire
on forward wheels it is recommended to install tires with deeper protector
install tires only of identical type and with the identical drawing of a protector
2. A fixing spring for a balancing small weight
3. Balancing small weight
on cast disks small weights fasten by means of glue
4. Wheel cap
 5. Bolt of fastening of a wheel
inhaling moment: 110 N.m.
M14 x 1.5 x 27.5 mm
6. Wheel disk
5-1/2J X 14, depth of a rim is 45 mm (for wheels with steel disks)
6 J X 14, depth of a rim is 45 mm (a disk from light alloys)
7. Camera valve
install the new valve when replacing a wheel

Wheel with a light-alloy wheel

1. Tire
for safety of the tire have to be replaced only with couples
on forward wheels it is recommended to install tires with deeper protector
install tires only of identical type and with the identical drawing of a protector
2. Balancing small weights
for installation: clear a wheel rim of oil and lubricant, remove a protective film from a small weight and paste it on a disk
3. A light-alloy wheel – trellised design 6J x 14
4. Nave cap
5. Cap
the blocking cylinder is installed
6. Blocking cylinder
is established on a wheel bolt
7. Bolt of fastening of a wheel
inhaling moment: 110 N.m.
M14 x 1.5 x 27.5 mm
8. Camera valve
install the new valve when replacing a wheel