Audi 80/90/Coupe
+ 1.2. Identification of the car
+ 2. Engines, carburetors
3. Lubrication system
+ 4. Cooling system
+ 5. Fuel system
+ 6. Exhaust system
+ 7. System of ignition
+ 8. Transmission
+ 9. Suspension brackets, wheels
- 10. Brake system
10.1.2. Brake shoes of forward brakes
10.1.3. Brake shoes of back brakes
10.1.4. General adjustment of back brakes (Girling)
10.1.5. Replacement of brake shoes (all-wheel drive models)
10.1.6. General adjustment of back brakes (Girling) (all-wheel drive models)
10.1.7. Forks of pedals of a brake and coupling
10.1.8. Adjustment of the emergency brake
10.1.9. Removal of the lever of the emergency brake
+ 10.2. Hydraulic components
- 10.3. Anti-blocking system of brakes
10.3.2. Hydraulic pump
10.3.3. Electronic control unit
- 10.3.4. ABS elements of a forward wheel
10.3.4.1. Sensors of speed of rotation of forward wheels
+ 10.3.5. ABS elements of back brakes
10.3.6. General comments on repair
+ 11. Steering
+ 12. Body, salon
+ 13. Air conditioning system
+ 14. Electric equipment
|
The ABS elements of a forward wheel (models till January, 1989)
1. Rubber plug
insert into an arm
2. The CV JOINT with a rotor
the external CV JOINT is on sale as spare honor with the established rotor
apply D6 glue on a junction of a half shaft and a nave of a wheel
3. Speed sensor
4. Sealing ring
always replace
5. 10 N. of m. | 6. Самоконтрящаяся nut
moment of an inhaling of 265 N. of m.
always replace
twist and turn off only when the car costs on the earth
when twisting apply D6 glue on a carving
7. Rack of the wheel bearing
is on sale as the spare part with the installed plug for fastening of the sensor of speed
8. Arm
for fastening of wires
9. 10 N. of m. |
The ABS elements of forward brakes (models after January, 1989)
1. Half shaft and CV JOINT
is on sale as the spare part with
the established rotor
does not stick together with a wheel nave
the number of teeths on a rotor is reduced by a half
in comparison with old modification
get the speed sensor before removal of a half shaft a little
2. The sensor of speed of rotation of a wheel is identical for
left and right parties
for removal: just pull out it from a nest
for installation: establish by fingers against the stop
3. Fixing plug
for installation: grease with liquid of brake
the cylinder also establish in a hug bearing rack nest against the stop | 4. 200 N. of m.
after twisting till the required moment of an inhaling turn in addition on a quarter of a turn (90o)
always replace
twist / turn off only when the car costs on the earth
5. Hug bearing rack
is on sale as the spare part with an opening for installation of the fixing plug and the sensor of speed |
|
|