Audi 80/90/Coupe
+ 1.2. Identification of the car
+ 2. Engines, carburetors
3. Lubrication system
+ 4. Cooling system
+ 5. Fuel system
+ 6. Exhaust system
+ 7. System of ignition
+ 8. Transmission
+ 9. Suspension brackets, wheels
- 10. Brake system
10.1.2. Brake shoes of forward brakes
10.1.3. Brake shoes of back brakes
10.1.4. General adjustment of back brakes (Girling)
10.1.5. Replacement of brake shoes (all-wheel drive models)
10.1.6. General adjustment of back brakes (Girling) (all-wheel drive models)
10.1.7. Forks of pedals of a brake and coupling
10.1.8. Adjustment of the emergency brake
10.1.9. Removal of the lever of the emergency brake
+ 10.2. Hydraulic components
+ 10.3. Anti-blocking system of brakes
+ 11. Steering
+ 12. Body, salon
+ 13. Air conditioning system
+ 14. Electric equipment
|
Emergency brake
|
1. Rotary pin
2. Cover
3. Lever of a parking brake
4. Handle
put on the lever so that the latch on the lever got to a loop on the handle
5. Switching off button
it is wound on a pusher
6. Compression spring
7. Latch
8. Doggie
9. Switch
for an alarm bulb of the emergency brake
10. Sheet spring
|
11. Lock ring
check correctness of installation
12. Cover
13. Equalizer
14. Adjusting nut
15. Bearing
16. Rotary pin
grind off a head for replacement of a rivet at installation of a new pin
17. Draft
18. Rotary pin
grind off a head for replacement of a rivet at installation of a new pin |
Adjustment of the emergency brake
As back brakes are self-regulating, you need to carry out their adjustment only after replacement: ropes of the emergency brake, supports of brakes, brake disks, brake shoes.
Always in the beginning carry out the general adjustment of back brakes.
| PERFORMANCE ORDER |
| |
1) tighten an adjusting nut of a rope of a parking brake so that both levers (one of them is specified by an arrow) rose from an emphasis (two mechanics are for this purpose necessary) |
|
2) put the adjusting clamp (it is specified by an arrow) back on two turns |
| |
3) by means of the screw-driver take away the support lever against the stop in turn on both back wheels |
| 4) the rope of the emergency brake is tense too strongly if the lever of one of supports departs from an emphasis |
| 5) weaken an adjusting nut of a rope of the emergency brake (it is specified by an arrow) so that both levers fell by an emphasis |
| 6) put the car on the emergency brake, and then remove |
| 7) check that both wheels rotated freely |
|
|
|