Audi 80/90/Coupe

since 1986-1991 release

Repair and operation of the car

Audi 80/90/Coupe
+ 1.2. Identification of the car
+ 2. Engines, carburetors
3. Lubrication system
+ 4. Cooling system
+ 5. Fuel system
+ 6. Exhaust system
- 7. System of ignition
   7.1.2. Specifications (4-cylinder models)
   7.1.3. Components of system of ignition for 5-cylinder models
   7.1.4. Specifications (5-cylinder models)
   7.1.5. CIS-E Motronic control unit (alarm block)
   7.1.6. Distributor rotor
   7.1.7. Ignition distributor (4-cylinder models)
   7.1.8. Ignition distributor (5-cylinder models)
   7.1.9. Components of system of ignition for 20-valvate models
   7.1.10. Specifications (20-valvate models)
+ 8. Transmission
+ 9. Suspension brackets, wheels
+ 10. Brake system
+ 11. Steering
+ 12. Body, salon
+ 13. Air conditioning system
+ 14. Electric equipment

7.1.8. Ignition distributor (5-cylinder models)


1) And – at the installed engine – establish a flywheel in the top dead point – the cylinder 1 (it is specified by an arrow)
In – at the removed engine – establish a tag on a vibroquencher (pulley) opposite to a tag on a belt cover (it is specified by an arrow)
2) level a tag on a cam-shaft asterisk with a cover of a head of cylinders (it is specified by an arrow)
3) install the distributor so that the rotor was directed to a tag for the cylinder 1 on a distributor casing (it is specified by an arrow)
4) clear a distributor cover before installation
5) check it regarding cracks and traces of soot as result of sparking, if necessary replace
6) adjust an ignition advancing corner


Idling speed, installation of a corner of an advancing of ignition and contents WITH are interconnected and have to be checked and be regulated together.