Audi 80/90/Coupe

since 1986-1991 release

Repair and operation of the car


Audi 80/90/Coupe
+ 1.2. Identification of the car
+ 2. Engines, carburetors
3. Lubrication system
+ 4. Cooling system
- 5. Fuel system
   - 5.2. Systems of injection of fuel
      5.2.1.2. Specifications (4-cylinder models)
      5.2.1.3. Components of system of injection for 5-cylinder models
      5.2.1.4. Specifications (5-cylinder models)
      5.2.1.5. Starting position of a plate of the sensor of an air stream
      5.2.1.6. Free wheeling of a plate of the sensor of an air stream
      5.2.1.7. Lever of a plate of the sensor of an air stream
      5.2.1.8. The operating plunger
      5.2.1.9. Throttle valve
      5.2.1.10. Rope of management of a butterfly valve
   5.2.2. Fuel injectors (20-valvate models)
   + 5.2.3. Electronic control system of the MPI engine
+ 6. Exhaust system
+ 7. System of ignition
+ 8. Transmission
+ 9. Suspension brackets, wheels
+ 10. Brake system
+ 11. Steering
+ 12. Body, salon
+ 13. Air conditioning system
+ 14. Electric equipment


5.2.1.10. Rope of management of a butterfly valve
GENERAL INFORMATION

Rope of management throttle zaslonoky, arrangement of components (4-and 5-cylinder models)
 
1. Throttle case
2. Basic arm
3. Rotary plug
for removal of the lever of a pedal break off fixing ledges (do not reuse the damaged rotary plugs)		 4. Pedal lever
acts only together with rotary plugs
5. Accelerator pedal
6. Rotary plug
7. Rope of management of a butterfly valve
8. Clamp

Adjustment

PERFORMANCE ORDER
1) at completely squeezed out accelerator pedal the lever of the throttle valve has to reach only just the provision of completely open butterfly valve (a free wheeling on the throttle lever – at most 1 mm)
2) if it not so
adjust a rope, inserting a clamp (it is specified by an arrow) at a basic arm

Removal

PERFORMANCE ORDER
1) disconnect a rope from a basic arm of a pedal and the lever of the throttle valve
2) break off fixing ledges from within salon (do not reuse the damaged ropes) and extend a rope through an engine compartment
3) replace laying and ring consolidations
4) record connections of hoses screw or spring clips
5) the correct work of components of electric system requires voltage at least 11.5 volts
Prevention

Flammablly! You do not smoke and do not bring to the field of repair anything from what can ignite fuel.