Audi 80/90/Coupe

since 1986-1991 release

Repair and operation of the car

Audi 80/90/Coupe
+ 1.2. Identification of the car
+ 2. Engines, carburetors
3. Lubrication system
+ 4. Cooling system
+ 5. Fuel system
+ 6. Exhaust system
+ 7. System of ignition
+ 8. Transmission
+ 9. Suspension brackets, wheels
+ 10. Brake system
+ 11. Steering
+ 12. Body, salon
+ 13. Air conditioning system
- 14. Electric equipment
   + 14.1.2. Thermoswitch, electronic thermoswitch
   - 14.2. Electrical wiring
      14.2.2. Modification of the rubber insulating plug of the contact plug
      14.2.3. Holders of additional safety locks
      14.2.4. Locations and identification of safety locks
      14.2.5. Identification of contacts on a payment of safety locks and blocks of the relay
      14.2.6. Additional fee of blocks of the relay
      14.2.7. The locations of plugs of a plait of wires in contact nests
      14.2.8. Points of grounding and welded connections of wires
      14.2.9. Locations of control units
      14.2.10. An arrangement of devices in office of the engine
   + 14.3. Electrical circuitries

14.2.3. Holders of additional safety locks

GENERAL INFORMATION

And – a casing of a payment of safety locks and blocks of the relay

In – a payment of safety locks and blocks of the relay

With – additional safety locks and their holders

In cars, since models of 1990, holders of additional safety locks act and established separately. Holders are attached to inside of a casing of a payment of safety locks and blocks of the relay.

Identification of holders of additional safety locks on color

S 23 – black
S 24 – blue
S 25 – red
S 26 – yellow
S 27 – brown
S 28 – white
S 29 – green
S 30 – gray

Prevention

Use of eight additional safety locks is possible. For the correct installation of safety locks use the suitable scheme of an electrical wiring.

The red plastic cap with the designation "Motor" is established on safety locks of system of electronic control of the engine to avoid casual removal of safety locks.

Removal

PERFORMANCE ORDER

1) uncover a payment of safety locks and blocks of the relay
2) disconnect (having hooked latches) a payment of safety locks from a casing (without disconnecting electric connections) and put it aside
3) using the small screw-driver, release a blocking ear of the additional holder of a safety lock
	4) press on the holder in the direction specified by an arrow and get it from a casing of a payment of safety locks

Installation

PERFORMANCE ORDER

1) insert the holder of an additional safety lock on the place, the blocking ear will not be latched yet

2) insert a payment of safety locks into a casing

3) establish a casing cover on the place